Washer repair problems we solve
Whether your washer won't drain, won't spin, or just stopped mid-cycle — Kodiak's Edmonton technicians will carry the most common washer parts on every truck. Most repairs are done on the same visit.
Not draining
Water left in drum after cycle. Usually a pump, filter, or lid switch issue. Deep dive →
Not spinning
Drum sits still or spins weakly. Often a drive belt, motor coupling, or control board. Deep dive →
Leaking water
Puddles under or around the machine. We trace the source fast. Deep dive →
Won't start
Machine unresponsive. Could be door latch, control board, or power supply. Deep dive →
Making loud noise
Banging, grinding, or squealing during cycle. Bearings or drum support.
Not filling with water
Inlet valve, water pressure, or lid switch may be at fault.
Shaking violently
Off-balance load, worn suspension rods, or levelling issue.
All major washer form factors
Modern laundry comes in seven main configurations. Each has different repair labour because the install style affects access. Here's what we service — and the few cases where we honestly recommend something else.
Front-Load Washer
The modern standard. Front-mounted round door, larger capacity, gentler on clothes. All major brands serviced.
Top-Load Washer
Lid on top, classic mechanical or modern impeller design. Long-lived workhorses. All major brands and models.
Stacked Washer + Dryer Pair
Two separate units connected by a stack kit. Labour runs a bit higher than freestanding because the upper unit often gets disconnected for service — we quote on diagnosis.
Laundry Centre / Unitized
Single-cabinet washer + dryer (Whirlpool, Kenmore, Frigidaire-style). We service most models. On units 15+ years old, parts can be discontinued — in that case we’ll tell you honestly.
All-in-One Combo
Single unit that washes AND dries (Samsung WashTower, LG WashCombo, GE Profile ventless). We service most. Some newer ventless sealed-drum systems we’ll diagnose on arrival and quote on-site.
Top-Load Washer + Stacked Dryer
Less common configuration — top-load washer on the floor, front-load dryer mounted above on a wall shelf. We service it; the install setup affects labour.
Portable Washer
Small countertop or rolling washers, common in condos. We focus on full-size laundry — portables are usually a replace-not-repair decision at this price point, and we’ll honestly say so.
Washer brands we repair in Edmonton
We service all major washer brands sold in Canada, including:
Washer repair cost in Edmonton
Labour for most washer repairs typically falls in the $220–$350 range — whether it's parts replacement (drain pump, door lock, motor coupler) or a labour-only fix (leveling, drum alignment, main board reset). Parts are quoted separately when needed.
Parts replacement or labour-only. Parts quoted separately when needed.
Applied toward repair if you proceed
Always disclosed before we start
Your firm quote comes from your tech after diagnosis, before any work begins. Full pricing details.
Strong hands, honest work.
Flat-Rate Pricing
You get a firm labour quote before we start. Parts shown separately on your invoice — no hidden fees, no hourly rates.
Insured & Warrantied
Every Kodiak job comes with liability insurance. Every part we install carries a 90-day warranty — the part and the labour to fit it. See what’s covered → Your home is protected — and so is the repair.
Ask us to look at your vent while we're there. If we're already in your home for any appliance repair, we'll inspect the dryer vent at no charge — it takes a couple of minutes and it's the cheapest problem in the house to catch early. Just ask when we arrive.
More Edmonton repairs
What to expect when you book
We confirm your appointment and give you an arrival window.
Your technician texts when on the way with a 3-hour arrival window.
Tech inspects the washer, runs error code checks, identifies the failed part.
Flat-rate labour, parts quoted separately. No pressure either way.
The most commonly needed washer parts will be on the truck. Back to your laundry as soon as the repair is done.
Common questions
Is it worth repairing my washer, or should I replace it?
A good rule: if the repair costs less than 50% of a new comparable washer and the machine is under 8 years old, repair. Our tech will give you a straight answer — we don't push repairs that aren't worth it. We have a full guide here: Repair or Replace?
My washer is shaking violently — is that dangerous?
Not immediately dangerous, but it shortens the machine's life fast. Usually it's an unbalanced load, worn suspension rods, or a levelling issue. We can typically fix it on the same visit.
Do you fix high-end washers like Speed Queen?
Yes. Speed Queen is one of the sixteen brands we service. These machines are built to last, and a fault on one is usually worth repairing rather than replacing the machine.
What if you can't fix it on the first visit?
If we need to order a part, we'll tell you on the spot with a firm total for parts and return-visit labour, then book the return visit as soon as the part arrives.
How soon will you be able to look at my washer?
We prioritise morning bookings where the routing allows. Get in touch and we’ll agree a day.
Washer down? Let's fix it.
Kodiak covers Edmonton and the Capital Region. Book a time online, or call with a question — we pick up.
Honest, flat-rate appliance repair in Edmonton and the Capital Region. Run by a working tech who wants to do it right.