Services Calgary Pricing About FAQ Blog Contact

Services Calgary Pricing About FAQ Blog Contact 587-404-7477 Request a Repair

BRAND SPECIALIST

Electrolux Smarter Living — Since 1969

Calgary Electrolux appliance specialists

Electrolux applianceRepair Calgary

Electrolux appliances bring European design and engineering to your home — Wave-Touch controls, Perfect Steam cycles, and IQ-Touch cooking. When one of those refined systems needs attention, Kodiak's Calgary techs know exactly where to look. We service the full Electrolux lineup.

Mon–Fri 8am–8pm

Flat-rate pricing

90-day warranty

Insured & warrantied

Request a Repair 587-404-7477

01

A Brand Built on European Craftsmanship

About Electrolux

Electrolux was founded in 1919 in Stockholm, Sweden, and today is one of the world's largest appliance manufacturers. In North America, Electrolux owns Frigidaire and has a long history of premium home appliances known for European design cues and features like Perfect Steam and Wave-Touch controls.

Electrolux appliances tend to be feature-rich — steam cycles, wine chill compartments, precision-temp fridges. That sophistication is a plus for daily use but means more potential failure points over time. We know the common weak points on the Electrolux platform.

1919

Year Electrolux was founded in Stockholm, Sweden

60+

Countries where Electrolux appliances are sold

1986

Year Electrolux acquired Frigidaire, its North American sister brand

Group brands sold in North America — Electrolux, Frigidaire, AEG

Honest note from Kodiak: Electrolux appliances are feature-rich and well-built. Ice maker issues on certain French door fridge models are a well-documented weak point in the industry. We'll always give you a straight diagnosis before recommending a repair.

02

Electrolux repairs we handle

Common problems — 6

Our Calgary technicians have seen every Electrolux failure mode. We’ll carry the most common parts on every truck so most repairs can be done in a single visit.

Front-Load Washer Bearing Failure

Electrolux front-loaders develop drum bearing wear around the 7-10 year mark. Loud spin cycles are the classic symptom. We diagnose whether bearing replacement is worth it on your specific model.

Wave-Touch Control Panel Damage

Moisture-related failures on Wave-Touch and IQ-Touch panels are common. We repair or replace the affected panel and can advise on how to prevent it happening again.

Perfect Steam Cycle Faults

Steam generator sensor issues can cause the Perfect Steam cycle to error out. We diagnose the steam circuit and replace the failed component.

Dishwasher Control Board Failure

Electrolux dishwasher control boards can fail from water intrusion or power surges. We diagnose whether it's the board itself or a triggered protection response.

French Door Fridge Water Dispenser

Water line and dispenser valve failures are common on Electrolux French door fridges. Usually a straightforward valve or line replacement.

Fresh-Chill Zone Temperature Issues

Electrolux precision-temp zones (Fresh-Chill, Wine, etc.) can drift if the zone thermistor fails. We test and calibrate before recommending parts.

04

Flat-rate pricing — no surprises

Pricing

You get a firm labour quote before we start. Parts shown separately on your invoice.

Standard repair

$220–$350

Labour for most Electrolux repairs — parts replacement or labour-only. Parts quoted separately when needed.

Service-call fee

$119

Applied toward your repair if you proceed. Covers diagnosis and travel.

Complex jobs

Higher — quoted on-site

Multi-part failures, jobs needing two people, appliances in tight or built-in spaces, and repairs where the time varies too much to flat-rate. Priced on diagnosis.

How it works: Labour is our flat rate, quoted before we start. Parts are quoted separately. Some parts take longer to source; we'll always tell you upfront.

05

Strong hands, honest work.

Why Kodiak

01

Calgary-based team

We're based in Calgary and know every neighbourhood. No call centre — just a local team that shows up when they say they will.

02

Insured & warrantied

Every Kodiak job comes with liability insurance. Every part we install carries a 90-day warranty — the part and the labour to fit it. See what’s covered → Your home is protected — and so is the repair.

03

Flat-rate pricing

We quote labour as a flat rate before we start. Parts shown separately — no hidden fees, no hourly clock running while we work.

06

Common questions

Electrolux repair FAQ — 6

Q1

Do you service both Electrolux and Frigidaire?

Yes. Frigidaire is owned by Electrolux and shares many platforms. We service both brands, and the shared platforms mean one parts habit covers a lot of both.

Q2

My Wave-Touch panel is unresponsive — is it repairable?

Often yes. Moisture damage is the most common cause. We can dry, clean, or replace the affected panel depending on severity.

Q3

Do you fix Electrolux built-in appliances?

Yes. We service Electrolux built-in wall ovens and column refrigerators. Note that built-in units sometimes require additional service time to access — we quote fairly for the extra work.

Q4

Are Electrolux parts easy to source in Calgary?

For common wear items — bearings, water valves, control boards — parts are readily available. For older or specialty parts, we may need a few extra business days to source through a distributor.

Q5

Can you repair the steam generator in a Perfect Steam washer?

Yes. We diagnose the full steam circuit (water valve, generator, sensors) and repair or replace the failing component.

Q6

Do you do warranty repairs?

We do post-warranty repairs only. If your appliance is still under the manufacturer's warranty, contact the brand directly to have an authorized warranty technician handle it. Once the warranty period has passed, we're happy to step in — flat-rate pricing, and a 90-day warranty on our own parts and labour.